Location

In selecting a location for your pellet unit, keep the following thoughts in mind.

  1. The pellet vent pipe and outside air kits both need to reach outside the structure so locating the unit on an exterior (outside) wall will allow the least complicated installation to be used.

  2. The unit cannot be vented below a window, between two windows, under a deck , or in an alcove.

  3. The unit must have a 3' (three foot) vertical rise in the flue system. This can be located either inside our outside of the structure.

Footprint

When looking for a good location for the unit inside the structure, you will want to first check out the " footprint" the stove will require.  The term "footprint" refers to the space the unit and its clearance areas will occupy.  For example , the 25-pdv is 281/2" wide and 281/2" deep  needs 6"  clearance in the front , rear and both sides so it  would have a 401/2" by 401/2" footprint.  No combustible materials would be able to be located within the footprint (furniture, drapes, etc).

Floor Protection

A "UL listed " floor protector is required to be placed under all of our freestanding pellet units unless they are being placed on a cement floor such as a basement floor.
 


 

Floor protectors come in various sizes:

For Models 25-pdv, 25-pdvt, 55-shp22, and 55-trp22, The minimum floor protector for these units is 36" X 36" which should allow at least six inches (6") of protection at the rear and each side, and six inches (6") minimum in the front of the unit.

For Models 25-pdvc, 25-pdvct, 55-shp10, and 55-trp10 The minimum floor protector for these units is 31" X 32" which should allow at least one inch (1") of protection at the rear, four inches (4") on each side, and six inches (6") in the front of the unit.

If you have any further questions or concerns, please contact Customer Service at:
1-800-245-6489

Copyright © 2005   England's Stove Works, Inc.   All rights reserved.
Revised:  11/07/2008

This web site, including all pictures, description and information of any sort contained therein is intended for the sole use of customers and representatives of England's Stove Works, Inc. No part of this web site or the information contained therein may be reproduced without express written permission from England's Stove Works, Inc..