Mobile Home Installation

NOTE: England's Stove Works recommends professional installation of our hearth products.
 

England's Stove Works pedestal based freestanding corn units are approved for mobile home or doublewide installation with outside combustion air hook-up. leg based units are not mobile home approved See "Flue System" section of manual. Mobile home installation should be in accordance with the Manufactured Home and Safety Standard (HUD), CFR 3280, Part 24.

WARNING: Do Not Install in Sleeping Room.

NOTE:

England's Stove Works strongly recommends installation of smoke and carbon monoxide detectors when installing ANY type of stove.

CAUTION:

The structural integrity of the mobile home floor, wall and ceiling / roof must be maintained.

Secure the heater to the floor using the two holes in the pedestal.  If the unit is on a combustible surface, you will need to drill matching holes in the floor protection that you choose.

Click here for Floor Protection Section

Do not disturb the structural integrity of the home, and be sure the unit is permanently electrically grounded to the chassis of your home.  Remember that outside combustion air is mandatory, and not to install the unit in a sleeping room of the home.

The England's  stove works pellet inserts are not mobile home rated.

Click Here for Through the Wall Installations

 

Click Here for Through the Roof Installations

(vent pipe)


Click on the Picture for Chimney Installations

If you have any further questions or concerns, please contact Customer Service at:
1-800-245-6489

Copyright © 2005   England's Stove Works, Inc.   All rights reserved.
Revised:  11/07/2008

This web site, including all pictures, description and information of any sort contained therein is intended for the sole use of customers and representatives of England's Stove Works, Inc. No part of this web site or the information contained therein may be reproduced without express written permission from England's Stove Works, Inc..